System Routing Table; Bandwidth Control - TP-Link TL-WR841N User Manual

Chapter 4
•
•
•
3. Select
4. Click
4 11 2
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
entries in use.
• Destination Network
to which the static route is assigned.
• Subnet Mask
network portion, and which portion is the host portion.
• Gateway
the Router and the network or host.
• Interface
WLAN (internal wired and wireless networks), or the WAN (Internet).
Click Refresh
4 12
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
3. Tick the
and
Downloaded from ManualsNet.com
Subnet Mask - The Subnet Mask determines which portion of an IP address is
the network portion, and which portion is the host portion.
Gateway - This is the IP address of the default gateway device that allows the
contact between the router and the network or host.
Interface - It is empty by default. Please select a connection from the dropdown
list if the Gateway is left empty or is not on the same network segment as LAN/
WAN interface.
Enabled or Disabled
Save.

System Routing Table

Advanced Routing > System Routing
- The Destination Network is the address of the network or host
- The Subnet Mask determines which portion of an IP address is the
- This is the IP address of the gateway device that allows for contact between
- This interface tells you whether the Destination IP Address is on the LAN &
to refresh the data displayed.

Bandwidth Control

Bandwidth Control.
Enable Bandwidth Control
Ingress Bandwidth, and then click Save. The
search engine
Configure the Router in Wireless Router Mode
for this entry on the Status
Table, and you can view all the valid route
checkbox, and configure the
drop-down list.
Egress Bandwidth
Egress/Ingress Bandwidth is the
51