Mounting The Unit On The Wall - Sharp SD-PX2 Operation Manual

Mounting the unit on the wall

SD-PX2
ENGLISH
Attaching the main unit bracket to the unit
1
Route all connection cables through the main unit bracket.
2
Attach the main unit bracket to the unit.
Fix them securely with the supplied 2 screws.
Do not use other screws. The unit may fall or break.
E-53
Main unit bracket
Place the main unit on a cushion or a
soft cloth to avoid damage.
Supplied screw
Mounting the main unit bracket on the wall
VESA (*) compliant fittings (commercially available) can be attached to the
main unit bracket.
A wall bracket and adaptor not supplied, but can be purchased.
Note:
(*) VESA (Video Electronics Standards Association) is an organization to promote
the standardization of digital imaging device for PCs.
Types of fittings:
Fittings must satisfy the following.
Compatible with the VESA standard.
Have a gap of 3.973" (100 mm) 3.973" (100 mm) between the screw holes on the
section to be attached.
Sturdy and stable to prevent fall or breakage.
3.973" (100 mm)
How to attach the main unit bracket
There are four VESA (*) screw holes on the main unit bracket. You can use com-
mercially available fittings for mounting.
Follow the method recommended by the bracket manufacturer.
3.973"
(100 mm)