Setting-Up The Projector; Connecting The Ac Power Cord - Sanyo PLC-EF12B Owner's Manual

PREPARATION
This projector uses nominal input voltages of 100-120 V or 200-240 V
AC. The projector automatically selects the correct input voltage. It is
designed to work with single-phase power systems having a grounded
neutral conductor. To reduce the risk of electrical shock, do not plug
into any other type of power system.
Consult your authorized dealer or service station if you are not sure of
the type of power supply being in use.
Connect the projector with the peripheral equipment before turning the
projector on. (Refer to pages 13 ~ 22 for connection.)
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and the proper AC power cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
Projector side
To the POWER CORD
CONNECTOR on the
projector.
8

SETTING-UP THE PROJECTOR

CONNECTING THE AC POWER CORD

For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect the AC Power Cord (supplied)
to the projector.
The AC outlet must be near this
equipment and must be easily
accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(200 - 240 V AC)
For the U.K.
To the AC Outlet.
(200 - 240 V AC)