Electrical Connection - IKEA SMAKLIG Manual

ENGLISH
590 mm
±1
490
mm
55 mm max.
R 5 mm
min. 38 mm
5 mm
Important!
• For further information on the installation
refer to the Assembly Instruction.
• If there is no oven beneath the hob insert
a dividing panel at a minimum distance of
20 mm from the bottom of the hob.

Electrical connection

Warning! Refer to Safety
chapters.
Warning! All electrical
connections must be made by an
authorised installer.
Electrical connection
• Before connecting, check that the
nominal voltage of the appliance, stated
on the rating plate, corresponds to the
available supply voltage. Also, check the
power rating of the appliance and ensure
that the wire is suitably sized to suit the
appliance power rating (refer to the
"Technical data" chapter). The rating plate
is located on the lower casing of the hob.
• The appliance is not provided with a
mains cable. Buy the right one from a
specialised dealer. Single phase or two-
min. 500 mm
520 mm
±1
560
mm
min.
100 mm
• Do not use silicon sealant between the
appliance and the worktop.
phase connection requires a mains cable
of minimum 70°C temperature stability.
Cable needs mandatory end sleeves.
According to IEC regulations use for one-
phase connection: mains cable 3 x 4mm²
and for two-phase connection: mains
cable 4 x 2.5mm². Please respect in first
priority specific national regulations.
• The appliance works perfectly on AC 230
V, AC 220 V~ or AC 240 V~ 50 Hz electrical
network.
• You must have the means for
disconnection incorporated in the fixed
wiring. Have the appliance connected to
the mains using a device that allows the
appliance to be disconnected from the
mains at all poles with a contact opening
width of at least 3 mm, eg. automatic line
protecting cut-out, earth leakage trips or
fuse.
31
min.
38 mm
min. 5 mm