FUTABA SBE-1 Quick Start Manual

S.BUS ENCODER
Instruction Manual
WARNING
Take t h e s a m e prot ecti ve m easur es
against vibration, shock, high temperature,
and the invasion of moisture with the SBE-1 as
you do with the receiver.
Name of Each Part and Connection Method
To conventional
system receiver
(up to 10chs)
* Connects all the connectors corresponding to the
channel necessary to operate the S.BUS device.
* Always connect the CH1 and CH2 connectors.
(To supply power to the SBE-1 and S-BUS device)
No signal Blinking
PWM input Steady light
* Lights when a regular signal is
received on any channel.
FUTABA CORPORATION
ÆS.BUS Converter
Precautions
1
2
3
3
4
5
5
6
7
7
8
9
10
[SBE-1 ratings]
Æ
6SHFL¿FDWLRQV DQG UDWLQJV DUH VXEMHFW WR FKDQJH ZLWKRXW QRWLFH
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
Note: Always read this manual before using the SBE-1.
Store this manual where it can be used at any time.
That you for purchasing an SBE-1 S.BUS
The SBE-1 is a converter that is used when using a
CGY750 gyro or other exclusive S-BUS receiver device
with a receiver for conventional system use.
The signals (PWM) of a conventional system of up to 10chs
can be converted to S.BUS system signals.
*1
S.BUS: Standard name of Futaba serial communication for R/C
systems.
CAUTION
Do not connect anything other than an
S-BUS device to the S.BUS output.
Futaba Corp. will not be responsible for
damages, etc. caused by combination with
other than Futaba Corp. products.
LED (green)
SBE-1
[Accessories]
*Use this adapter to connect the output connector
to an S.BUS Hub with Cable, etc..
μ
*1
* Co nnects t o t he S. BU S in put
connector of an S.BUS device.
To S-BUS device
©FUTABA CORPORATION
encoder.
2011, 7 (1)