Using The Metronome - Casio keyboard PX-320 User Manual

Selecting and Playing a Tone

Using the Metronome

1.
Press the METRONOME button.
• This will start the metronome.
• The two lamps above the START/STOP button will
flash along with the metronome beats.
Flashes on the first beat
of each measure.
2.
To change the beats per measure, hold down
the METRONOME button as you press the
/NO or /YES button.
• You can select a value in the range of 2 through 6.
A chime sounds as the first beat of each measure, and
the remaining beats sound as clicks. Specifying 0 as
the setting plays a straight click, without any chime.
This setting lets you practice with a steady beat.
3.
Press the FUNCTION button.
• This will cause the button's lamp to flash.
4.
Use the /NO and
the tempo in a range of 20 to 255 beats per
minute.
5.
Press the FUNCTION button again.
• This will cause the lamp above the button to go out.
6.
To stop the metronome, either press the
METRONOME button again or press the
START/STOP button.
NOTE
• See "Other Settings" on page E-32 for information about
another method you can use to configure the metronome
setting.
E-14
Flashes on
subsequent beats.
/YES buttons to adjust
Slower Faster
To adjust the metronome volume
NOTE
• You can perform the following procedure at any time,
regardless of whether or not the metronome is sounding.
1.
Press the FUNCTION button.
• This will cause the lamp above the button to flash.
2.
Press the METRO VOL button.
• This will cause the lamp above the button to flash.
3.
Use the /NO and
the metronome volume in the range of 0 to 42.
4.
Press the FUNCTION button again.
• This will cause the lamp above the button to go out.
/YES buttons to change