Enabling Traffic; Viewing Traffic On The Map; Searching For Traffic Incidents; Vehicle And Driver Tools - Garmin DEZL OTR610 Owner's Manual

Adding a subscription
You can purchase traffic subscriptions for other regions or countries.
1 Select Settings > Traffic.
2 Select Subscriptions >
3 Write down the FM traffic receiver unit ID.
4 Go to www.garmin.com/fmtraffic
The traffic subscription code cannot be reused. You must obtain a new code each time you renew your
service. If you own multiple FM traffic receivers, you must obtain a new code for each receiver.
5 Select Next on the device.
6 Enter the code.
7 Select Done.

Enabling traffic

Before you can enable traffic, you must connect your device to a compatible traffic receiver cable.
You can enable or disable traffic data.
1 Select > Traffic.
2 Select the Traffic tick box.

Viewing traffic on the map

The traffic map shows colour-coded traffic flow and delays on nearby roads.
1 From the main menu, select
2 If necessary, select

Searching for traffic incidents

1 From the main menu, select
2 Select > Incidents.
3 Select an item in the list.
4 If there is more than one incident, use the arrows to view additional incidents.

Break Planning

This device by itself is NOT an approved substitute for logbook recording requirements under US Federal Motor
Carrier Safety Administration (FMCSA) regulations. Drivers should comply with all applicable hours-of-service
requirements. When integrated with a Garmin eLog compliant Electronic Logging Device (ELD), the Garmin eLog
device enables a motor carrier to comply with hours of service logging and break requirements. For more
information, or to purchase a Garmin eLog device, go to garmin.com/elog.
When the break planning feature is enabled, the device notifies you one hour before suggested break times and
drive hour limits and suggests break locations on your route. You can use this feature to keep track of your
working hours, which may help you comply with safety regulations.
NOTE: break planning features are not available when using the car vehicle profile.

Taking a suggested break

When it is time for a break, the device notifies you and displays suggested break location POIs along your route.
Select a POI from the list of suggested break locations.
The device adds the break location as the next destination on your route.

Vehicle and driver tools

.
to purchase a subscription and get a 25-character code.
> Traffic.
> Legend to view the legend for the traffic map.
> Traffic.
Vehicle and driver tools
NOTICE
39