Operation - Ariens Sno-Thro 920 Series Owner's/Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: To avoid injury to hands
and feet, always disengage clutches,
shut off engine, and wait for all
movement to stop before unclogging
or working on snow thrower.
Keep hands and feet away from
auger and impeller.
CONTROLS AND FEATURES
See Figure 10 for all Controls and Features
locations.
Dual Handle Interlock
When Attachment Clutch and then Traction
Drive Clutch are engaged, the Attachment
Clutch will remain engaged (lever down) if
released. To stop attachment, release
Traction Drive Clutch and both clutches will
disengage.
Traction Drive Clutch - Left Hand
Lever
2
1
OL2701
NOTE: When traveling to or from the area to
be cleared, press down on the handlebars
enough to raise the front of the unit slightly off
the surface. Engage the traction drive clutch
without engaging the attachment drive clutch.
Attachment Clutch - Right Hand
Lever
2
1
OL2691

OPERATION

Squeeze the Traction
Drive Clutch Lever
against the Handlebar (1)
to engage wheel drive for
propelling unit. Forward
speed will vary according
to snow depth and
moisture content.
Release lever (2) to stop
movement.
Squeeze Attachment
Clutch Lever against
handlebar (1) to
engage attachment.
Release both clutch
levers (2) to disengage
power and apply brake
to attachment.
IMPORTANT: If the belt squeals when the
attachment clutch lever is engaged, the
impeller may be frozen in the auger housing.
Immediately release the attachment clutch
lever and move the unit into a heated area to
thaw.
NOTE: If belt squeals when impeller turns
freely, see Replace Attachment Drive Belt on
page 26.
Ignition Switch
Primer Bulb
Speed Selector
Position the Speed Selector in the
appropriate speed notch to control forward
and reverse travel.
6
Forward:
(6) Fastest
(1) Slowest
Reverse:
IMPORTANT: DO NOT change motion from
forward to reverse with clutch engaged.
Forward speed can be changed without
declutching.
GB - 15
Operate the ignition switch with
the removable key. To start the
engine, turn the key to Start. To
stop the engine, turn the key to
Off.
Pushing the primer bulb
in adds fuel for easier
engine start. Refer to
Starting and Shut Off on
page 19.
1
(1) Slow
(2) Fast
1 2