Zoom G1X Service Manual page 10

6. Press the [BANK UP・TAP] key (SW1) of the receiver, and make sure that the 7 segment
LED lit "rx". The receiver is ready to receive the data.
7. Press the [Rhythm] key (SW2) of the transmitter and make sure that the 7 segment LED
lit "tx". The indication flashes on and off at once. And the transmitter starts to send the
data. When sending and receiving finish successfully, and make sure that Transmitter
and Receiver's both 7 segment LED are displayed same check-sum.
8. Turn the both transmitter and receiver off.
9. Take the wires away and attach the bottom plate.
- 10 -