General Information - HUSTLER TrimStar Parts Manual

Hide thumbs Also See for TrimStar:

Operator's manual (46 pages)

General service manual (43 pages)

Owner's manual (26 pages)

Table Of Contents

Table of Contents

Note: When ordering parts, you must use the part number as shown for each part, not the index number. Always give

the model and serial number to your parts and service representative.

Note: Items sold in bulk such as seals and hoses are sold by the foot.

Using This Manual

This manual is part of a service package for the Hustler

mower and component manuals will provide the information necessary to service and maintain Hustler

This Parts Manual provides a complete parts listing for the unit. Use this manual when ordering parts. Illustrations used

were current at the time of printing, but subsequent production changes may cause your machine to vary slightly in

detail. Excel Industries, Inc. reserves the right to redesign and change the machine as deemed necessary, without noti-

fication. If a change has been made to your machine which is not reflected in this parts manual, see your authorized

dealer for current information and parts.

The Service Manual is a service guide for use by Service Technicians. It provides the necessary information needed to

perform normal maintenance requirements on these units.

The Operator's Manual provides fundamental operational information and operational safety that is needed when oper-

ating the mower.

The component manuals are furnished by the various manufacturers to be used for the troubleshooting and servicing

of their products.

Hardware Description Codes & Abbreviations

The following codes are used throughout this parts manual. Refer to this list when ordering parts.

ABBREVIATION

FDRW

Standard Torques

The following chart lists the standard torque values for the threaded fasteners found in this manual. Torque all cap

screws, nuts and set screws to these values unless a different torque is shown in the Notes section next to the fastener.