Samsung SyncMaster 757MB Owner's Manual page 16

Connecting 1. Setup-General
Your Monitor
Installing the
Monitor Driver
Base Installation
1. Connect the power cord for your monitor to the power port on the back of the monitor.
2. Connecting the signal cables.
3. Connect the USB cable to the USB port on the back of your monitor/computer.
4. Turn on your computer and monitor. If your monitor displays an image, installation is complete.
2. Setup-For Multimedia model
1. Setup-General
Plug the power cord for the monitor into a nearby outlet.
1) Connecting to the PC.
(Connect the signal cable to the 15-pin D-sub connector on the back of your monitor. Connect
the signal cable to the video port on your computer, video board, video card, or graphics card.)
2) Connecting to old Macintosh models
If you are using a Macintosh computer, connect the cable to a Macintosh adapter, and set the
pins on your adapter(Adapter not included). A PC-compatible computer does not need an
adapter.
3) When you use a BNC connector.
Connect the signal cable to the BNC signal port on the back of your monitor/computer.
(You need it to use the MouScreen program.)
SyncMaster 957MB
| 2. Setup-For Multimedia model
Main > Setup > Connecting Your Monitor
| 3. Multimedia Speaker Stand