Delta Electronics SM3300 Series Product Manual page 21

FRONT MENU OPERATION
SOUNDS
• Select the sound for each indicator separately.
• Possible settings are 1xCHANGE, 3xCHANGE,
• DOWNWARDS and CONTINUOUS BEEP.
LANGUAGE
For firmware package P0120 the language available is
'ENGLISH'.
POWER-ON STATE
VOLTAGE
• Select CV setting of the unit after mains switch on.
• Possible settings are ZERO, FIXED VALUE and
• RESTORE VALUE.
• Default setting is ZERO.
CURRENT
• Select CC setting of the unit after mains switch on.
• Possible settings are ZERO, FIXED VALUE and
• RESTORE VALUE.
• Default setting is ZERO.
OUTPUT
• Select OUTPUT ON / OFF-setting of the unit after mains
switch on.
• Possible settings are DISABLED, ENABLED and
• RESTORE VALUE.
• Default setting is DISABLED.
PRG SOURCE
V-SETTINGS
• Select programming source for the CV-setting.
• Possible settings are NONE, FRONT, ETH, WEB, SEQ
and SLOT1...4.
• Default setting is FRONT.
I-SETTINGS
• Select programming source for the CC-setting.
• Possible settings are NONE, FRONT, ETH, WEB, SEQ
and SLOT1...4.
• Default setting is FRONT.
POWERSINK
STATUS
• Displays current state
• Displays the temperature of the power sink
SETTINGS
• Shows the settings for the optional power sink.
• Settings can be done via the web interface as well.
• Possible settings are Power Sink disabled/enabled, Power
Sink on RSD, Interlock and/or Output On/Off.
MASTER SLAVE
STATUS
• Displays id number, configuration status and number of
units (if device is master).
SETTINGS
• Select and view the setting for the master/slave interface.
• Selection can be done via front or via the web interface.
• Possible settings are master, slave or off.
• Select nr of units in parallel or in series.
SETUP
RECALL SETUP
• Recall an earlier saved setup of the menu settings,
voltage and current settings and limits, network settings.
• Choose Setup1, Setup2 or Setup3.
SAVE SETUP
• Save the present settings.
21 / 32 DELTA ELEKTRONIKA B.V.
SM3300
rev. June 2022