Getting Started; Accessories List; Installing The Stand Or Wall Mount Bracket - Toshiba 43C350KN Owner's Manual

Accessories List

The following accessories are included with TV:
OWNER'S MANUAL Base Stand × 2
AAA Battery × 2 Screw × 4
RCA jack to AV Cable × 1
NOTE
• The accessories may be different from the list above due to different
models, countries/regions. Please refer to the actual accessory bag.

Installing the Stand or Wall Mount Bracket

CAUTION
• Be sure to disconnect the AC power cord before installing a stand or
Wall-Mount brackets.
• The display on your TV is fragile. Make sure the TV screen is not
scratched or damaged by hard objects or from pressure.
• After the installation is complete, make sure the TV is steady on a table
or firmly attached to a wall mount, before removing all protective film,
if any.
Installing the Stand
1. Carefully place your TV face-down on a soft, flat surface to prevent
damage to the TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert the
stands into the bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory tightly.
43"/50"/55"
Base Stand
65"
Base Stand
Screws: M5×12 (65")

Getting Started

Remote Control × 1
Power Cord × 1
Screws: M4×16 (43")
M4×12 (50"/55")
Base Stand
Installing the Wall Mount Bracket
Before mounting the TV, remove the TV stand if you have already attached it,
and make sure the wall mount bracket supports the weight of your TV.
CAUTION
When mounting the TV on a wall, follow instructions provided with the
wall mount bracket. If it is not correctly mounted, the TV may fall and cause
property damage or personal injury.
Place spacers between the TV and bracket.
Make sure the tilt angle between the TV
screen and the vertical surface is no more
than 15 degrees.
Standard dimensions are shown below.
Wall mount hole pattern (mm)
Wall mount screw size
8.0 - 10.0 mm (43"/50"/55")
9.5 -11.5 mm (65")
Rear cover of the TV
Follow instructions provided with the wall mount bracket.
NOTE
• The diameter and length of the screws differ depending on the wall
mount bracket model.
• Wall mount bracket is optional. Your TV may not have wall mount bracket.
Please refer to the actual accessories.
Installing the P-Clip
Please place the TV on a horizontally stable surface, and then use P-Clip to
connect the TV and the wall or pillar.
1. Fix the larger side of P-Clip to the screw hole on the back of TV set with a
M6×12 screw.
2. Fix the other side of P-Clip to the wall or pillar with a ST4×25 screw.
NOTES
• Insecure installation may cause the tilt or falling of the product, and
further lead to personal injuries or product damages.
• P-Clip and corresponding screws may not included with TV set. Please
purchase them by yourself if necessary.
• The picture is only for reference.
5
≤15°
Vertical
surface
TV screen
200 × 300 (43"/50"/55")
400 × 300 (65")
M6
Wall Mount Bracket
Wall Mount Screw
Wall Mount Spacer