Table of Contents
Advertisement
Adjusting a Drawbar Organ Tone in Real
Time
Use the sliders and buttons to adjust drawbar organ tones in
real time.
To do this:
Adjust tone harmonic
Shift sliders D-4 (16') through D-12
overtone levels
(1') upwards and downwards.
• Shifting one of the sliders
• You also can configure the level
Add or remove
Use the D-2 (PERCUSSION
percussion sound with
SECOND) and D-3 (PERCUSSION
2nd overtone and 3rd
THIRD) buttons.
overtone pitch to a
• Each press toggles the button
tone
• The corresponding overtone
Switch the rotary
Press the D-1 (ROTARY SLOW/
effect speed (rotation
FAST) button.
*2
speed)
• Each press toggles the button
• Rotary speed is fast while the
*1 Adjustment to one of four levels, from 0 to 3, is supported.
Each level is indicated by the level meter as shown below.
*2 This operation is supported only when DSP is being used
as the effect and the DSP type is "Rotary". For details
about effects, see "Applying Effects to a Sound" (page
E-29). For details about DSP types, see "DSP Effect List"
(page E-155).
Do this:
upwards or downwards changes
the harmonic overtone of the
corresponding foot "length" from
its current level (the level preset
*1
for the tone).
meter so it indicates the harmonic
overtone level of each slider
position. For more information,
see "To configure the level meter
to show the harmonic overtone
level of each slider position"
(page E-51).
between lit and unlit.
percussion is being applied to
notes while a button is lit, and not
being applied while it is unlit.
between lit and unlit.
button is lit and slow when it is
unlit.
Using Drawbar Organ Tones
To configure the level meter to show the
harmonic overtone level of each slider
position
1.
Perform steps 1 through 3 of the procedure
under "To select and play with a drawbar organ
tone" (page E-50).
• The level meter shows the harmonic overtone levels for
the foot "lengths" preset for the currently selected
drawbar organ tone.
• You also could skip this step and start from step 2 of
this procedure, if you want.
2.
Hold down the R-12 (MANUAL) button until the
foot "length" values (16' through 1') along the
top of the level meter flash twice. You can
release the button at this time.
• This will cause the level meter to indicate the current
positions of sliders D-4 (16') through D-12 (1'), and
apply applicable harmonic overtone levels to the
current tone.
3.
Shift sliders D-4 (16') through D-12 (1') upwards
and downwards.
• When you do, the displayed harmonic overtone levels
will change accordingly in the level meter.
4.
Now you can play on the keyboard using the
level-adjusted tone.
E-51
Advertisement
Table of Contents
