Table of Contents
Advertisement
To edit an existing rhythm
1.
Perform steps 1 through 6 under "To rehearse
before editing an existing rhythm" (page E-104).
2.
Perform the procedure under "To configure
pattern rec settings (Rec Menu)" (page E-106).
• This step is not necessary if you want to perform
operations using initial default settings or if you want to
use previous settings without changing them.
3.
Press the L-14 (NORMAL/FILL-IN) or L-15
(VARIATION/FILL-IN) button to select the
accompaniment pattern you want to edit.
• You cannot edit the INTRO or ENDING
accompaniment pattern of an existing rhythm. If you
want to create a new accompaniment pattern (INTRO,
ENDING, etc.) from this point, see "To create a new
accompaniment pattern" (page E-109) or "To create a
new rhythm from scratch" (page E-111).
4.
Use the R-17 (u, i) buttons to select the
instrument part you want to edit.
Currently selected accompaniment pattern
Currently selected instrument part status
See "Instrument Part Editing and Rec Areas" (page E-102).
5.
Configure mixer settings for the selected
instrument part. You can skip this step if you do
not want to configure mixer settings.
• Here you can press the L-17 (START/STOP) button to
start playback of the accompaniment pattern and
configure mixer settings as you monitor the effects of
the settings on the notes being played.
Currently selected instrument part
Using the Pattern Sequencer
(1) Press the C-7 (MIXER) button to display the mixer
screen.
(2) Use the R-17 (t, y) buttons to select one of the
items described in the table below and then use the
dial or R-14 (–, +) buttons to change the setting.
Display:
Item name
TONE:
Specifies the instrument part
Part tone
tone.
Part:
Toggles an instrument between
Part On/Off
sounding (on) and not sounding
*2
(oFF).
Volume:
Specifies the instrument part
Part Volume
volume.
Pan:
Specifies whether the sound of
Part Pan
the part can be heard from the
left side or right side.
Reverb:
Specifies the level of reverb
Part Reverb
(page E-31) applied to the
Send
instrument part.
Chorus:
Specifies the level of chorus
Part Chorus
(page E-31) applied to the
Send
instrument part.
*1 You can select any preset tone except for the drawbar
organ tones. Only drum set sounds (tone numbers J:129
through J:146) can be selected for drum parts and
percussion parts. Drum set sounds cannot be selected for
the bass and the Chord 1 through Chord 5 parts.
*2 You can temporarily sound the notes of individual parts, if
you want. For details, see step 5 under "To rehearse
before editing an existing rhythm" (page E-104).
*3 A smaller value shifts the pan position to the left while a
larger value shifts to the right. A value of zero specifies
center.
(3) To exit the mixer, press the C-7 (MIXER) button or the
R-15 (EXIT) button.
• This returns to the pattern sequencer screen.
Setting
Setting
Range
*1
oFF, on
000 to 127
–64 to 00 to
*3
+63
000 to 127
000 to 127
E-107
Advertisement
Table of Contents
