Spillover Mode - Strymon El Capistan User Manual

El Capistan
- dTape Echo
Power Up Modes

Spillover Mode

Setting El Capistan to Spillover mode allows the echo repeats of the
currently selected preset to "spill" into bypass or the next loaded preset�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1 Press and hold the ON footswitch while powering up El Capistan�
Once both LEDs flash, release the footswitch�
2 Turn the TAPE AGE
on or off� Both LEDs will change color to indicate the current status
as you turn the knob�
• Spillover mode Off:
• Spillover mode On:
3 Press either footswitch to store the Spillover mode setting and begin
using El Capistan�
NOTE: The Spillover mode setting persists across power cycles and is not
saved per preset�
(SPILLOVER MODE) knob to turn Spillover mode
AMBER (default)
PURPLE
pg 17