Roland DIF-AT24 Owner's Manual page 11

Settings
Sampling Frequency settings
Set the sampling frequency of your sequencer software and the VS-2400CD to the same
setting (44.1 kHz or 48 kHz).
Master Clock settings
Master clock device
VS-2400CD
Sequencer software
You'll also need to set the Master Clock for your sequencer software. For details on this setting, refer to the
owner's manual for your sequencer software.
Synchronization settings
Set the VS-2400CD's parameters as follows.
MMC settings
If using the sequencer software
as the MMC master
MIDI PARAMETER screen
SysEx. Rx. Sw...................... On
MMC MODE....................... SLAVE
MMC SOURCE................... R-BUS
MTC settings
If using the sequencer software
as the MMC master
SYNC PARAMETER screen
SYNC MODE ...................... EXT
EXT SYNC SOURCE.......... R-BUS
FRAME RATE..................... Same setting as the
* Check the specifications of your sequencer software, and set your software and the VS-2400CD to the same
frame rate.
In order to synchronize operation with your sequencer software, you'll also need to make settings in the
sequencer software. For details on these settings, refer to the owner's manual for your sequencer software.
VS-2400CD setting
PROJECT PARAMETER screen
MASTER CLOCL ................INT
PROJECT PARAMETER screen
MASTER CLOCL ................R-BUS
If using the VS-2400CD as the MMC master
MIDI PARAMETER screen
If using the VS-2400CD as the MMC master
YNC PARAMETER screen
software.*
MASTER CLK switch
MIDI OUT/THRU ............. Out
SysEx. Tx. Sw ...................... On
MMC MODE....................... MASTER
SYNC MODE ...................... INT
FRAME RATE..................... Select the MTC
MIDI OUT SYNC Gen ....... MTC
Connections and settings
DIF-AT24
R-BUS
ADAT
type.*
11