Table of Contents
Advertisement
Replacing the Wired Remote Controller
Battery
The wired remote controller is powered by a single CR2025
lithium battery.
1.
While pressing the bat-
tery holder lock, pull
the battery holder from
the wired remote con-
troller.
2.
After wiping off the two
sides of a battery with a
soft, dry cloth, place it
into the battery holder
with the positive (+)
side facing up (so you
can see it).
3.
Slide the battery holder back into place.
UNPACKING
Battery
holder
Battery
holder lock
E-22
Failure of the wired remote controller to operate probably
means that the battery needs to be replaced.
Battery Precautions
• Keep batteries out of the reach of small chil-
dren. If swallowed accidentally, contact a phy-
sician immediately.
• Misuse of a battery can cause it to leak, which
damages and corrodes the area around the
battery and creates the danger of fire and per-
sonal injury. Be sure to observe the following
precautions.
• When loading the battery, make sure its posi-
tive (+) and negative (–) sides are facing cor-
rectly.
CAUTION
• Use only the battery type that is specified for
this unit.
• Never try to charge a battery or take it apart,
and never allow its poles to become connected
to each other by metal (shorted). Do not ex-
pose batteries to heat or dispose of them by
burning.
• Dead batteries tend to leak battery fluid. Never
leave a dead battery in the wired remote con-
troller.
Advertisement
Table of Contents
