Samsung T19C301 Series Service Manual page 84

White Ratio (Balance) Adjustment
„
1. You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
2.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS,
Component 1 and HDMI 1 modes.
3. The optimal values for each mode are configured by default. It varies with Panel's size and Specification.
• Equipment : CA210
• Pattern: MIK K-7256 #92 "Flat W/B Pattern" as standard
NOTE
Use other equipment only after comparing the result with that of the Master equipment.
• Set Aging time : 60min
Calibration and Manual setting for WB adjustment.
• HDMI : Calibration at #24 Chessboard Pattern → Manual adjustment #92 pattern (720p)
• COMP: Calibration at #24 Chessboard Pattern → Manual adjustment at #92 pattern (720p)
• CVBS: Calibration at #24 Chessboard Pattern→ Manual adjustment at #92 pattern (NTSC)
NOTE
• If finishing in HDMI mode, adjustment coordinate is almost same in AV/COMP mode.
4. Troubleshooting 4. Troubleshooting
4-43 4-43