Operation; Starting Engine; Restarting Engine While Engine Hot; Stopping Engine - RedMax HBZ2500 Owner's/Operator's Manual

Operation

STARTING ENGINE

1. Rest the unit on a flat, firm place.
2. Pump the primer until fuel flows out in the
clear tube.
3. Move the choke lever upward to close the
choke.
4. Holding the blower handle, pull the starter
rope with your right hand. (Throttle lever in
idling position.)
NOTE
Avoid pulling the rope to its dead end or
returning it by releasing the knob. Such
actions can cause starter failures.
5. When the engine has started, move the
choke lever gradually downward to open
the choke.
6. Allow the engine to warm up for a half
minute before starting operation.
10
RESTARTING ENGINE WHILE ENGINE IS HOT
1. When restarting the engine immediately
after stopping it, leave the choke open.
2. If the engine won't start after several
attempts, close the choke and repeat
pulling the rope or remove the spark plug
and dry it.

STOPPING ENGINE

Move the throttle lever to the idling position
and press the stop switch (red button) until
the engine comes to a complete stop.
NOTE
Except for an emergency, avoid stopping the
engine while pulling the throttle lever.

ADJUSTING IDLE SPEED

1. When the engine tends to stop frequently
at an idle mode, turn the adjusting screw
clockwise.
NOTE
Warm up the engine before adjusting the idle
speed.