Advertisement
Attentions:
Press the "ON/OFF" (1) to start the green control box, press (2) "
" and "
" button to
adjust the temperature SV (3) ( the heating temperature could be set to 380 ℃ when
welding the HDPE).
1. Meanwhile press the "O/Ⅰ"(5) to start the heat gun, adjust the knob (6) to set heat
gun temperature and air volume ( for PVC rod welding: 5-6 grade, for HDPE rod welding
6-7 grade).
Pre-heating 30 second, the first lamp on panel (4) is turns to green means that the
temperature PV(real-time temp) is reach to SV setting temp, can start to weld.
When third lamp "ALM1" is light up means that the PV (4) temperature is reach to 300℃,
the extruder's trigger(8) can start up.
2. Put the welding rod into suitable feed inlet (7), press the motor trigger(8). You could
adjust the motor speed by trigger too.
8 / 9
Advertisement
