THOMSON SpeedTouch 350 Setup And User Manual page 15

E-DOC-CTC-20031204-0011 v2.0
Windows will automatically recognize the THOMSON USB Remote NDIS device:
3
The Windows Found New Hardware Wizard appears:
4
This wizard will guide you through the installation procedure of the SpeedTouch™
USB drivers.
Click Next to continue.
The following windows of the Found New Hardware Wizard allow you to select
5
locations where it should search for drivers:
Insert the SpeedTouch™ Setup CD-ROM, make sure that the wizard looks for the
drivers on the CD-ROM drive and click Next to continue.
The wizard will notify that it found drivers for the THOMSON USB Remote NDIS
6
device on the CD-ROM.
Click Next to continue.
The installation procedure continues with the installation of the USB Remote
7
NDIS drivers.
In the following windows you can follow the installation procedure. Click Next
8
whenever requested to continue the installation.
At the end of the procedure, the following window appears:
9
Click Finish to complete the installation.
As a result your USB connection is installed and ready for use.
10
1 SpeedTouch™ Installation
13