Table of Contents
Advertisement
ACR air curtains
10.
OPERATION AND MAINTENANCE
The engine and fan of the ACR air curtains are maintenance-free devices but regular check-ups are advised, especially motor and
bearing (fan's rotor should rotate freely, free from any axial and radial throws/run-outs and undesired knocks/rattles.
The heat exchanger requires systematical cleaning of all dirts /impurities off. Before the start of the heating period, the heat exchanger
is advised to be cleaned with compressed air directed to the air outlets; there is no need for dismantling of the device.
Pay special attention when cleaning the exchanger's fin due to high possibility of damaging them. If the fin is bent use a special tool. If
the device has not been used for a longer period of time, unplug it before the next use.
The heat exchanger is not equipped with any fire protection device. The heat exchanger may be damaged if the room temperature
goes below 0°C; anti-freeze liquid must be added to the water circulation/system. Anti-freeze liquid must be appropriate for the
material the exchanger is made of (copper) as well as other elements of the hydraulic system/circulation. The liquid must be diluted
with water accordingly to the manufacturer's recommendation.
NOTICE !
•
Any and all repair and maintenance works must be conducted with the power off and the heat
input disconnected.
•
Only suitably qualified staff well acquainted with the safety regulations concerning handling
with an electrical device must be employed when the device is being installed, started and op-
erated
•
In the event of coolant leak, when the water system is under pressure, any repairs of the leak-
age are strictly prohibited.
•
Any repairs of the device must be conducted only if the device is disconnected from the power
supply.
•
If the device being operated gives metallic clatter, vibration or the level of noise is increasing,
check if the
•
mounting of the fan has not become loose – in case of any problems contact the installer of the
device or the
•
PAKOLE TRADE Kft. Authorized Service immediately.
11.
TROUBLESHOOTING AND TECHNICAL PROBLEMS
Possible problems and solutions are shown below. To eliminate a problem encountered contact the PAKOLE TRADE Kft. Authorized
Service.
Fault, symptoms
No heating, fan not operating
Heating medium leakage
• leakage on joints with hot water supply system
• leakage in collector
Heat output drop
Operation and Maintenance Documentation
Potential causes
No power supply
Damage to the fan
Damage to the switches on control panel
Loss of tightness
Temperature of the heating medium differs
from the required one Contaminated heat
exchanger's surface
Solutions
Check the power switch Check the
power supply Check the power cable – if it is dam-
aged - replace the cable
Replace the motor
Check the switches – if are damaged – replace
Sealing supply system; repairing the heat exchanger
Restore the temperature of the heating medium
Clean the surface of the heat exchanger
17
Advertisement
Table of Contents
