Toro Workman GTX Series Installation Instructions Manual
Bed rack kit
Hide thumbs
Also See for Workman GTX Series:
- Operator's manual (60 pages) ,
- Installation instructions manual (8 pages) ,
- Operator's manual (60 pages)
Advertisement
Quick Links
Bed Rack Kit
Workman
Model No. 07031
This product contains a chemical or chemicals known to the State of California to
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or lost.
1. Attention—read the Operator's Manual; do not exceed load
weights of 18 kg (40 lbs).
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX Series Utility Vehicles
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
133-7204
Register at www.Toro.com.
WARNING
CALIFORNIA
Form No. 3406-387 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3406-387* A
Printed in the USA
Advertisement
Related Manuals for Toro Workman GTX Series
Summary of Contents for Toro Workman GTX Series
- Page 1 Replace any decal that is damaged or lost. 133-7204 1. Attention—read the Operator’s Manual; do not exceed load weights of 18 kg (40 lbs). © 2016—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3406-387* A...
- Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Prepare the machine. Side upright frame bracket Front upright frame bracket Pipe bracket Front support bracket (with 2 holes on each side) Cross-support bracket Fire-extinguisher mount...
- Page 3 2. Install the 3 shovel mounts to the side upright frame 4. Install the pipe bracket to the 2 side upright frame brackets with 12 carriage bolts (5/16 x 3/4 inch) and brackets and front upright frame bracket with 6 carriage 12 flange nuts (5/16 inch) as shown in Figure bolts (5/16 x 3/4 inch) and 6 flange nuts (5/16 inch) as...
- Page 4 6. Install the front support bracket (with 1 hole on each 8. Install the fire-extinguisher mount to the side upright side) to the 2 front upright frame brackets with 2 frame bracket and front upright frame bracket with 4 carriage bolts (5/16 x 3/4 inch) and 2 flange nuts (5/16 carriage bolts (5/16 x 3/4 inch) and 4 flange nuts (5/16 inch) as shown in Figure...
- Page 5 9. Install the fire-extinguisher support or cup-cutter 10. Tighten the hex-head screws (1/4 x 3/4 inch) in steps bracket to the side upright frame bracket and front to 1,130 N∙cm (100 in-lb). upright frame bracket with 2 carriage bolts (5/16 x 3/4 inch) and 2 flange nuts (5/16 inch) as shown in Figure Figure...
- Page 6 When you complete installation, the Bed Rack Kit appears as follows: Left side installation—Figure 11 Both sides installation (additional parts required)—Figure 13 Figure 11 Right side installation (optional configuration)—Figure Figure 13 Figure 12...
- Page 7 Notes:...