Pioneer SERATO DJ DJM-900SRT Firmware Update Manual page 14

<STEP4>
<STEP5>
D. Check the current DJM-900SRT version to make sure that the update was
completed:
Make sure that the update process has been completed.
The following "SUCCESS" message appears on the VFD display if the update is
successfully completed.
Restart DJM-900SRT.
If any changes were made in the above "1. Change network settings" of this
chapter, please restore the network settings to the previous values.
<STEP1> While holding [CUE (BEAT EFFECT)] and
[ON/OFF (BEAT EFFECT)] buttons, press the Power
button to go into update mode.
<STEP2> Make sure that the latest version has
been installed.
If the current version, "x.xx," is displayed, the update
has been successfully completed.
- 14 -