Table of Contents
Advertisement
4.24 System Reboot
Reboot the Switch in software reset. Click
4.25 Rate Control
You can set up every port's bandwidth rate and packet limitation type.
■ Limit Packet type: select the packet type that want to filter. The packet types have all type packet,
broadcast/multicast/unknown unicast packet, broadcast/multicast packet, and broadcast packet only.
The broadcast/multicast/unknown unicast packet, broadcast/multicast packet, and broadcast packet
only are only for ingress packet. The egress rate only supports all type packet.
■ The port1 ~ port 8, supports port ingress and egress rate control. For example, assume port 1 is
10Mbps, users can set it's effective egress rate is 1Mbps, ingress rate is 500Kbps. The switch
performs the ingress rate by packet counter to meet the specified rate.
Ingress: select the port effective ingress rate. The valid range value is 1MB, 2MB, 4MB, 8MB,
16MB, 32MB and 64MB. The default value is "disable".
Egress: select the port effective ingress rate. The valid range value is 128kbps, 256Kbps,
512Kbps, 1MB, 2MB, 4MB, and 8MB. The default value is "disable".
■ Click
button to apply the configuration.
[NOTE]
1.
Remember to execute the "Save Configuration" action, otherwise the new configuration will lose
when the switch power off.
button to reboot the switch.
System Reboot interface
Advertisement
Table of Contents
