Table of Contents
Advertisement
3.2 Configuration
In this screen, you can configure the wireless settings of WL-8317. After configuration,
please press "Apply" to save settings or "Cancel" to set again.
SSID: The SSID must be identical for each clients and nodes in the wireless network.
Wireless Mode: Click pull-down button and select the work mode below.
Ad-Hoc: This mode indicates the peer-to-peer operation. All communication is done
from client to client without the use of an Access Point.
Infrastructure: This operation mode requires the presence of an Access Point. All
communication is done via the Access Point.
Ad-Hoc Band: There are three options available for selection
11B: Allows user to set the 802.11b standard wireless network.
11G: Allows user to set the 802.11g standard wireless network.
Channel: Shows the number of the radio channel used for the networking.
Tx Rate (11B/G): Shows the Data Transfer Rate. If Auto Mode is selected, the device will
choose the best transfer rate automatically.
Power Mode: Shows Power Management modes. There are two optional selections for
this mode.
Continuous Access Mode: WL-8317 will always set in active mode.
Maximum Power Save: WL-8317 will enter power saving mode when it is idle.
Power Save: WL-8317 consumes the moderate level of power.
Preamble: There are two options can be selected: Short & Long Preamble, Long
Preamble. Preamble is a sequence of bits transmitted at 1Mbps that allows the PHY
9
Advertisement
Table of Contents
