Storage - Craftsman 944.365550 Owner's Manual

CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualifi ed
service center for repair or ad just ment.
IMPORTANT: Never tamper with the
engine governor, which is factory set
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thor oughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING" in the Maintenance sec-
tion of this manual).
2. Lubricate as shown in the Main te nance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fas tened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your mower han dle for storage.
1. Loosen the two (2) handle knobs on
sides of the upper handle and allow
handle to fold down to the rear.
2. Remove the two (2) handle knobs and
carriage bolts on sides of the lower
handle and pivot entire handle as-
sem bly forward and allow it to rest on
mower.
3. Reinstall knobs and carriage bolts to
lower handle or handle brackets for
safe keeping.
• When setting up your handle from the
storage position, the lower han dle will
require manually locking into the mow-
ing position.
IMPORTANT: When folding the handle for
storage or transportation, be sure to fold
the handle as shown or you may damage
the control cables.
for proper engine speed. Over speed ing
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Sears or other
qualifi ed service center, which has proper
equip ment and ex pe ri ence to make any
nec es sary adjustments.

STORAGE

Operator
presence
control bar
FOLD
FORWARD
FOR
STORAGE
Handle
bracket
Knob
ENGINE
Maintenance, re pair, or re place ment of
the emission con trol de vic es and sys tems,
which are be ing done at the cus tom ers ex-
pense, may be performed by any non-road
engine repair es tab lish ment or individual.
Warranty repairs must be performed by an
authorized engine man u fac tur er's service
outlet.
15
MOWING
POSITION
Upper
handle
Handle
knob
Lower handle
Bolt