Troubleshooting
Considerable noise in radio broadcasts.
The remote control does not function.
The display is dark.
Low hum or buzz sound.
Low bass response.
Unable to select Progressive Scan
The 9 and some buttons on MCD759D
and its remote control have no function.
44
✔
Tune in to the correct frequency.
✔
Connect the antennas.
✔
Fully extend the FM wire antenna. Position for
best reception and secure to a wall.
✔
Connect an outdoor FM or AM antenna.
✔
Adjust the direction and position for best
reception.
✔
Place the antenna farther away from any
equipment that may be causing the noise.
✔
Increase the distance between the system and
your TV or other equipment.
✔
Select the correct source (DISC or TUNER, for
example) before pressing the function button.
✔
Point the remote control at the remote sensor
of the unit.
✔
Reduce the distance to the player.
✔
Remove any possible obstacles.
✔
Replace the batteries with new ones.
✔
Check that the batteries are loaded correctly.
✔
Press DIM again.
✔
Place the DVD micro system as far away as
possible from electrical devices that may be
causing interference.
✔
Check all speakers for correct polarity.
✔
Check that the output of the video signal is
switched to 'Pr/Cr Pb/Cb Y'.
✔
The playback of the docked player cannot be
stopped using the 9 button on MCD759D and
its remote control.
Only the following buttons are available: 2;,
✔
¡1, 2™, 3, 4, DISPLAY/MENU and OK.