Sharp AR-RP7 Service Manual page 3

2. Remove the glass holders (right and left) and remove
the document glass.
Remove the right and left glass holders and remove the document
glass.
Remove the two screws (M3x8) of the left glass holder and the three
screws (M3x8) of the right glass holder.
Screws (M3x8)
Document glass
Left glass
holder
3. Attach the RSPF glass holder.
Insert the RSPF glass holder to the document glass.
Then, attach the document glass to the copier, fix the left glass holder
that has been removed in step 3 using two screws (M3x8), and fix the
RSPF glass using three screws (M3x8).
Screws (M3x8)
Document glass
Left glass
holder
4. Attach the RSPF.
Insert the hinge portion of the RSPF to the mounting portion of the
copier by holding the RSPF at an angle toward the rear side.
Hinge
Screws (M3x8)
Right glass holder
Screws (M3x8)
RSPF glass holder
Hinge
AR-RP7 UNPACKING AND INSTALLATION
– 2 –
5. Remove the filament tape.
Remove the filament tape located in the positions shown in the illustra-
tion.
Filament tape
Filament tape
6. Connect the relay connector.
Connect the Centronics connector of the RSPF to the connector of the
copier and then tighten the screws of the connector.
Screw
7. Attach the intermediate tray.
Insert the intermediate tray all the way into the RSPF.
Intermediate tray
Filament tape
Screw