■ Assembly of USB PCB
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Order of fixing
Screw
Screw
Connect the coaxial cable from LCD.
CAUTION
Tighten of Screw
Set on the top.
W-LAN Cable
Connection
EXT Antenna PCB
is set
Tighten of
Screw
Tighten of
Screw
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
PCB USB Sub is set
Safety Working
S2
S2
Attach the Tape
Process the cable from LCD.
Along the groove
Attach the kapton tape into CD Edge Sheet.
7-28
Safety Working
Attach the Antenna Cable Sheet
Fit to the groove.
Difference : 1 or less
Antenna Cable
Plate is set
Tighten of Screw
Pull W-LAN Cable out to the surface from the hole.
Match to the board edge.
Difference: less than 1
Match to the CN edge.
Difference: less than 1
S1
Safety Working
Cable USB is set