Advanced Settings; Register The Handsets; Unregister The Handsets; Restore Default Settings - Philips AQ95-56F-1224KR User Manual

13 Advanced settings

Register the handsets

You can register additional handsets to the base
station. The base station can register up to 5
handsets.
Auto registration
1
Place the handset on the base station.
The handset detects the base station
»
and start to register automatically.
Registration is completed in less than 2
»
minutes. The base station automatically
assigns a handset number to the handset.
Manual registration
If auto registration fails, register your handset
manually to the base station.
1
Press MENU on the handset.
2
Select [ADVANCED SET] >
[REGISTER], then press [OK] to confirm.
3
Press and hold
seconds until you hear a confirmation beep.
4
Enter the system PIN. Press [BACK] to
make corrections.
5
Press [OK] to confirm the PIN.
Registration is completed in less than 2
»
minutes. The base automatically assigns
a handset number to the handset.
Note
•
If the PIN is incorrect or no base is found
within a certain period, your handset displays
a notification message. Repeat the above
procedure if registration fails.
Note
•
The preset PIN is 0000. No change can be
made on it.
EN
30
on the base station for 5

Unregister the handsets

1
If two handsets share the same base
station, you can unregister a handset with
another handset.
2
Press MENU.
3
Select [ADVANCED SET] >
[UNREGISTER], then press [OK] to
confirm.
4
Select the handset number to be
unregistered.
5
Press [OK] to confirm.
The handset is unregistered.
»
Tip
•
The handset number displays beside the
handset name in standby mode.

Restore default settings

You can reset your phone settings to the
original factory settings.
1
Press MENU.
2
Select [ADVANCED SET] > [RESET],
then press [OK] to confirm.
» The handset displays a confirmation
request.
3
Press [OK] to confirm.
All settings are reset.
»
The welcome screen displays.
»
Tip
•
For more information about the default
settings, see the section on Default settings.

Network type

Note
•
This feature only applies to models with
network type support.
1
Press MENU.
2
Select [ADVANCED SET] >
[NETWORK TYPE], then press [OK].
3
Select a network type, then press [OK].
» The setting is saved.