Installing The Compressor - BENDIX SNA-01 Service Data

OPTION 1
FIGURE 12A - TOP COOLANT FITTING OPTIONS
FIGURE 12 - REQUIRED ORIENTATION OF THE INLET AND TOP COOLANT FITTINGS

INSTALLING THE COMPRESSOR

1. Install the front flange o-ring on the pilot of the front
flange of the compressor. Gasket sealants are
not recommended. Secure the compressor on the
engine and tighten the mounting bolts per the Engine
Manufacturer's recommended torque requirements.
FIGURE 13 - DISCHARGE JUMPER ASSEMBLY
OPTION 2
0°± 5°
Coolant Fitting Orientation
20°–25°
Inlet Fitting Orientation
Lubricate O-rings and
O-ring Grooves
Top Coolant Fitting
Inlet Fitting
2. Install any supporting brackets on the compressor in the
same position(s) noted and marked during removal. If
a rear support bracket was on the original installation,
hand tighten the bolts on both ends before torquing the
bolts. Note: It is important that the rear support bracket
is flush to both surfaces before the bolts are torqued.
Discharge Jumper
Assembly Orientation
15