Advertisement
THRESHOLD
Under sun level: RED LED
Over sun level: GREEN LED
By pressing MODE button > 2 sec. > the light will start blinking for
30 sec. + feedback motor.
•
Adjust the sun threshold with the potentiometer.
The blinking led will be green once you have reached the current sun level.
The level you set will be the one to set off the sun function
•
Verify the functioning.
Let the demo mode works (if no sun, use a lamp)
•
Enter the "USER" mode.
By pressing MODE button > 2 sec. > feedback motor
•
DEMO mode will move back automatically after 3 min. in USER mode.
•
MOUNTING INSTRUCTIONS
•
o
Make sure to install sensor vertically and in place where solar cells can
catch daylight intensity.
•
o
Sensor delivered without screws, use the screw adapted to your wall
support.
SUN FUNCTIONNING
Use the Telis with sun function to activate or deactivate the sun function (Telis Soliris RTS, Telis
Modulis Soliris RTS.)
Manual Mode: Sun function deactivated.
Automatic mode: Sun function activated.
•
Sun appearing
When the intensity of the daylight exceeds the threshold set by the Sunis sensor RTS, a Down
order is sent to the blind after 2 mins. The blind goes to the MY position or to its down end limit
position if no My position has been memorized.
•
Sun disappearing
When the daylight level fails below the threshold setting, a variable time delay from 12-30
mins. is activated (depending on the sun presence duration). After this time delay, an UP order
is given to the blind.
64
USER MODE
Continues light during 5 sec.
Continues light during 5 sec.
DEMO MODE
Blinking light during 30 sec.
Blinking light during 30 sec.
Advertisement
