Usb-A Connector P601, P602 - HP OMEN 27u Maintenance And Service Manual

Remove USB-C connector
2) Lift the P600 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.

USB-A connector P601, P602

Repair the USB-A connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You can gently
push down with the soldering iron once everything is molten to move the P601, P602 out of the through
holes.
Remove USB-A connector
2) Lift the P601, P602 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
18