Advertisement
To Extinguish
1, Open c opy cover
—and place squffer firmly
over heater head.
2. Close canopy.
NOTE:- Do not pack heater until it
has cooled 20-30 minutes.
To Transport
Before truel secure
heater in upright posi-
tion to avoid possible
fuel spillage
Replacing The Wick
USE ONLY COLEMAN LIQUID FUEL. NEVER USE C NTAMINATED WHITE GASOLINE OR LEADED GASOLINE.
o
UNLEADED GASOLINES WILL DRASTICALLY SHO EN THE LIFE OF YOUR PRODUCT.
Model 512A708
1. Remove canopy and head by rotating to the left, counter-clo k-
wise. (Fig. 7)
2. Using a pipe wrench, remove spacer tube. Lift out old w k
assembly and gasket. (Fig. 8)
3. Carefully unwrap corrugated protector pad from wick. Be s e
sealing tape comes off clean. DO NOT SLIDE protector pad off f
the wick—open it up and unwrap it. The new wick is tied w h
asbestos string to prevent the top of it from fraying out. Be ca -
ful in handling and installing that this tie is not disturbed. Straigh n
bottom of wick so that it will contact bottom of tank.
4. Install new gasket. Set new wick in place. Screw down spacer
tube firmly. Insert fibre-glass filter in top of spacer tube, making
sure filter is %" below top of wick tube. (Fig. 9)
5. Reinstall head, reversing instructions.
(Fig. 7)
Models 513A708 and 515A708
1. Set red heat control lever to middle position.
2. Open canopy.
3. Place snuffer on heater head.
4. Grasp heater head with both hands, exerting downward pres-
sure turn heater head slightly counter clock-wise and lift off. It
may assist in removing the head if you have a helper hold tank from
turning. (Fig. 10)
5. Turn metal sleeve on exposed wick until it unlocks and lift out
old wick. (Fig. 11)
6. Replace with new wick, making certain new wick is inserted
into tube in catalytic heater head (Fig. 12).
7. Discard old "0" ring and replace
8. Reinstall head, reversing instructions.
(Fig. 8)
(Fig. 9)
new "O" ring provided.
Advertisement
