Setting Printhead Support - Avery Dennison Monarch 9844 Operator's Handbook Manual

05/08 Rev. AB

Setting Printhead Support

1. For narrow labels, turn the adjusting wheel clockwise until the pointer
2. Print a test print and check for even print quality. If the print quality is still
3. Repeat steps 1 to 3 until the print quality is the same across the entire width
OPERATOR'S HANDBOOK
9844/9854
When printing narrow labels, the printhead may come into contact with the
print roller where there is no material. This can lead to premature wear of the
printhead and to different print intensity between the two edges of the label.
When using narrow labels, enable the printhead support. Small = material
width < printhead width.
Change the printhead support by using the adjusting wheel (1). Position 0 is
recommended for wide labels.
Fig. 1: The adjusting wheel for the printhead support.
indicates 1 on the dial. This causes the printhead to be raised at the outside.
uneven, turn the adjusting wheel a little further.
of the label.
2-14
Setup