Paradyne Hotwire ATM Line Cards 8335 User Manual page 63

Procedure
To enter SN Configuration screen information:
8335-A2-GB20-70
1. Select the interface to be changed (dsl1:1 through dsl16:1 on the
Model 8335, dsl1:1 through dsl12:1 on the Model 8365, or dsl1:1 through
dsl24:1 on the Model 8385).
2. Position the cursor in the field on the top half of the screen that you wish to
modify. Type the value you want and press Enter.
For . . .
Name
Contact
Location
Circuit ID
NOTES:
— The fields listed above are stored in the Paradyne enterprise MIB.
Values for these fields may have already been retrieved from the
attached endpoint if this information has been configured at the
endpoint. If no information is provided from the endpoint, you can
enter it here. If you attempt to enter information into fields already
configured at the endpoint, your entries will not be saved.
— The fields at the bottom of the screen are read-only. This information
is retrieved from the endpoint when the line is operational. If the
endpoint does not provide information for one or more of these fields,
blanks are displayed.
3. Press Ctrl-z and save the changes as prompted.
February 2003
Enter . . .
Up to 16 alphanumeric characters to identify the endpoint
(Default = blank).
Up to 32 alphanumeric characters to identify the person or
organization responsible for the endpoint
(Default = blank).
Up to 16 alphanumeric characters to identify the
location of the endpoint (Default = blank).
Up to 32 alphanumeric characters to identify the circuit
(Default = blank).
3. Configuration
3-41