Paradyne Hotwire ATM Line Cards 8335 User Manual page 121

Table B-1. SNMP Traps (5 of 6)
Event
hdsl2ShdslpowerBackoff
hdsl2ShdsldcContinuityFault
hdsl2ShdslconfigInitFailure
hdsl2ShdslprotocolInitFailure
hdsl2ShdslnoNeighborPresent
hdsl2ShdsllocalPowerLoss
mpeSelfTestFailure
mpeDevFileXferEvent
pdnAtmIfConfExtExcessInvalid
CellsAlarm
pdnAtmIfConfExtLineRateAlarm
Set
pdnAtmIfConfExtLineRateAlarm
Clear
pdnAtmIfConfExtVclNoBandwidth
Avail
pdnAtmIfConfExtLineRateAlarm
Set
8335-A2-GB20-70
Description
The bit setting for power backoff for this
endpoint has changed.
The bit setting for the DC continuity fault
for this endpoint has changed.
The bit setting for the config init failure for
this endpoint has changed.
The bit setting for the protocol init failure
for this endpoint has changed.
The bit setting for no neighbor present for
this endpoint has changed.
Impending unit failure due to loss of local
power (last gasp).
Hardware failure detected during selftest.
Contains information about a file transfer.
The number of cells with uncorrectable
HEC errors has exceeded the
user-defined threshold.
Line rate dropped below a value which
violates traffic contracts of connections.
Line rate has risen above a value which
would no longer violate traffic contracts of
connections.
Traffic contracts associated with the VC
cross connect cannot be satisfied by the
ATM switch.
Configuration has changed so that the
previously valid CAC contracts can no
longer be guaranteed in the egress
direction.
February 2003
B. SNMP Traps
Variable Bindings
IfIndex
hdsl2ShdslInvIndex
hdsl2ShdslEndpointSide
hdsl2ShdslEndpointWirePair
hdsl2ShdslEndpointCurrStatus
IfIndex
hdsl2ShdslInvIndex
entPhysicalIndex
mpedevSelfTestResults
mpeDevFileXferName
mpeDevFileXferType
mpeDevFileXferOperation
mpeDevFileXferErrorStatus
mpeDevFileXferStatus
IfIndex
pdnAtmIfConfExtUnknownCell
Threshold
IfOperStatus
IfIndex
IfIndex
AtmVcCrossConnectIndex
AtmVcCrossConnectLowIfIndex
AtmVcCrossConnectLowVpi
AtmVcCrossConnectLowVci
AtmVcCrossConnectHighIfIndex
AtmVcCrossConnectHighVpi
AtmVcCrossConnectHighVci
IfIndex
B-5