Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac E4 Series User Manual

FIGURE 12
16. Repeat steps 11 through 15 for other wheel
assembly.
17. Return tank to upright position.
ACCESSORY BASKET
ASSEMBLY
(Not standard with all models)
FIGURE 13
FIGURE 14
20. Press down until basket is secured into place.
TOOL HOLDER
ASSEMBLY
(Not standard with all models)
21. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
FIGURE 15
15. Slide axle housing into
dovetail slot at rear of tank:
axle housing is tapered and
should slide into dovetail
slot without excessive force.
FIGURE 12. Tighten screw.
18. With rear of tank facing
you, take accessory basket and
position with tabs facing rear of
tank. FIGURE 13.
19. Insert tabs of accessory
basket into slots on rear of
tank. FIGURE 14.
22. With rear of unit facing
you, take tool holder and
position it with the tabs
facing rear tank cover.
FIGURE 15.
FIGURE 16
24. Press down until tabs snap into place.
NOTE: TOOL HOLDER NOT COMPATIBLE WITH
ACCESSORY BASKET.
FILTER
INSTALLATION
AND CLEANING

DRY PICK UP OPERATION

WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
KEEP FILTERS CLEAN. EFFICIENCY OF THE
VACUUM IS LARGELY DEPENDENT ON THE
FILTER. A CLOGGED FILTER CAN CAUSE
OVERHEATING AND POSSIBLY DAMAGE THE
CLEANER. CHECK THE FILTER PERIODICALLY
AND REPLACE AS REQUIRED.
INSTALLING FOAM SLEEVE AND REUSABLE
DRY FILTER:
(Not standard with all models)
To pick up dust and dry material, you must install foam
sleeve and reusable dry filter to ensure proper filtration.
If the vacuum has been used to pick up liquids, the foam
sleeve must be cleaned and dried before installing for dry
pick up.
FIGURE 17
23. Press tabs of tool holder
into the slots on mounting
lugs on rear of tank cover.
FIGURE 16.
25. With tank cover in an
upside down position, slide
foam sleeve down over lid
cage pulling until foam sleeve
completely covers lid cage.
FIGURE 17.
NOTE: Bottom of foam sleeve
must be positioned on the
OUTSIDE of groove around lid
cage for the reusable dry filter
to fit properly.
PAGE 6