Table of Contents
Advertisement
11. Help
Display
"MESSAGE FULL"
"MODEM ERROR"
"NO FAX REPLY"
"OPEN CABINET
CHECK FILM SLACK"
"OPEN CABINET
CHECK FILM TYPE"
"PAPER JAMMED"
"PLEASE WAIT"
"POLLING ERROR"
"RECORDING ERROR"
"REDIAL TIME OUT"
"REMOVE DOCUMENT"
"SERIAL ERROR"
"TRANSMIT ERROR"
"UNIT OVERHEATED"
11.2.2 Cordless handset
Display
"Answer Sys. Full"
"Error"
"Failed"
"Incomplete"
"Invalid Number"
66
Cause & Solution
L There is no room left in memory to record voice messages. Erase
unnecessary messages (page 46, 47).
L There is something wrong with the unit's modem. Contact our service
personnel.
L The other party's fax machine is busy or has run out of recording paper. Try
again.
L Please use genuine Panasonic replacement film (page 9).
L The ink film is slack. Tighten it (see step 5 on page 14).
L The fax machine is positioned near appliances such as TVs or speakers
which generate an intense magnetic field.
L A recording paper jam occurred. Remove the jammed paper (page 74).
L You forced the recording paper into the paper tray too strongly. Remove all
of the installed paper, and re-install it gently.
L The unit is checking that there is no slack or crease in the ink film. Wait for
a moment while the check is completed.
L The other party's fax machine does not support polling. Check with the
other party.
L The greeting message you recorded was under 1 second long. Record a
longer message.
L The other party's fax machine is busy or has run out of recording paper. Try
again.
L The document is jammed. Remove the jammed document (page 75).
L Press {STOP} to eject the jammed paper.
L There is something wrong with the unit and the base unit will not work.
Contact our service personnel.
L A transmission error occurred. Try again.
L If you send a fax overseas, try the following:
– Make sure the other party's number is a fax number.
– Use the overseas transmission mode (feature #23 on page 51).
– Add 2 pauses at the end of the telephone number or dial manually.
L The unit is too hot. Stop using the unit for a while and let the unit cool down.
Cause & Solution
L Erase unnecessary messages (page 46, 47).
L Recording was too short. Try again.
L Phonebook copy failed. Confirm the destination unit is in standby mode and
try again.
L The destination unit's phonebook memory is full. Erase the unnecessary
phonebook items from the destination unit and try again.
L You tried to send an SMS message to a phone number saved in the base
unit phonebook, cordless handset phonebook, Caller ID list, or redial list
that is over 20 digits long.
Advertisement
Table of Contents
