Troubleshooting - Panasonic AJ-PCS060G Operating Instructions Manual

ERROR LED display (continued)
No.
27
R
28
R
29
1) To clear the error display, press the [POWER] button and [CANCEL] button together.
No.
30
R
OR

Troubleshooting

If the unit seems to be malfunctioning, try checking the following points. If the problem persists,
contact the place of purchase.
The POWER LED does not light after the
[POWER] button is pressed.
Copying does not start after a P2 card is inserted
and the [START] button is pressed.
The [REMAIN] LEDs do not light after the [
button is pressed.
The [REMAIN] LEDs do not light after the [HDD
CAP] button is pressed.
The unit's internal partition names are not displayed
in Windows Explorer when the unit is connected to
a computer with the USB 2.0 cable.
P2 cards cannot be formatted.
The POWER LED merely flashes after the
[POWER] button is pushed.
E-31
REMAIN
A Verify NG error has occurred
when the Verify function was
OR
executed independently.
An error occurs when the Verify
NG error occurred the time
before, operation was terminated
OR
without checking it, and then the
power is turned on.
The sensor has detected
impact to the HDD, and an
OR
error has occurred.
COPY STATUS
OR OR OR
Symptom
Status
Status
During P2
access, the P2 card
was pulled out and an
OR
error occurred.
• Is the battery pack drained?
• Is the AC adapter connected correctly?
• Is there enough space for copying on the internal HDD?
• Is an error displayed indicating that internal HDD
temperature is over or under the prescribed level?
]
• Is the POWER LED lit (green)?
• Is the POWER LED lit (green)?
• Is the unit processing copy or format operations?
• Does the computer support USB 2.0 connections?
• Is the operating system Windows XP SP2 or later, or
Windows 2000 SP4 or later?
• Is the unit correctly connected to the computer?
• Is the network drive assigned a letter immediately
after the letters of the computer's hard drive or CD-
ROM drive?
• Is the write-protect switch set to PROTECT?
• Is the P2 card inserted correctly?
• Are you attempting to turn the unit ON in
temperatures below 5 °C (41 °F)?
Corrective Action
After clearing the error display
try copying the data again.
After clearing the error display
try copying the data again.
After ensuring the unit is away
from the source of impact keep it
off for a while.
Corrective Action
card
Turn the unit OFF and ON.
What to Check
,
1)
1) ,