Panasonic AJ-PCS060G Operating Instructions Manual page 18

Copying (continued)
Canceling copy operations
You can cancel copying in progress as follows.
1. Hold the [CANCEL] button for at least 2 seconds
The [COPY STATUS], [P2C], and [HDD] LEDs change as follows.
: LED lit
OR : orange
OR
2. Press the [POWER] button
Copying is canceled and the [COPY STATUS] LEDs go out.
Note:
Canceling copy automatically deletes copied data.
Formatting
Formatting P2 cards
You can delete all data on P2 cards.
Data cannot be recovered after formatting. Before formatting cards, make sure all the data may
safely be deleted.
Do not turn the unit OFF or eject P2 cards when the [P2C] LED is flashing.
This may damage the P2 card.
P2 cards cannot be formatted if the write-protect switch is set to PROTECT. Additionally, when P2
cards are inserted in the slot, you cannot adjust the write-protect switch to prepare them for formatting.
1. With the unit ON, insert a P2 card in the slot
2. Hold the [P2C] button for at least 2 seconds
The [COPY STATUS], [P2C], and [HDD] LEDs change as follows.
: LED lit
OR : orange
OR
3. Within 2 seconds, press the [START] button
The [COPY STATUS], [P2C], and [HDD] LEDs go out, and P2 card formatting begins.
Formatting is complete when the [P2C] LED flashes in orange.
Note:
While the [COPY STATUS], [P2C], and [HDD] LEDs are on in step 2, if you do not press the [START]
button within 2 seconds (step 3), the P2 card will not be formatted. To format the card, repeat the
process from step 2.
E-17
COPY STATUS
OR OR OR
: LED flashing
COPY STATUS
OR OR OR
OR
− −
OR
OR
−