Calling Up Readings From Memory; Setting (Checking) The Measurement Notification Time - Panasonic EW3037 Operating Instructions Manual

Calling up readings from memory

Fig. 11-a Readings can be recalled after being saved without
having to switch the unit on.
1. Press the Memory/Recall button.
• The average readings of all recorded measurements
are displayed.
• The
• When, for example, readings from 90 measurements
Fig. 11-b have been saved the average of the readings from 90
measurements will be displayed.
M / R
2. Press the Memory/Recall button to display readings
starting with from the most recent measurement.
Fig. 11-c
• Each time the Memory/Recall button is pressed
readings are displayed in order of the most recent
measurement (Fig. 11-c, 11-d).
• No readings will be displayed when there are none in
the memory.
3. Press the On/Off and Start button to switch off the
unit.
(After approx.
one second.)
If you forget to switch off the unit it will do so
Fig. 11-d
automatically after approx. 30 seconds.
Deleting all data stored in memory
(1) Recall stored data using the Memory/Recall button.
(2) Press the Memory/Recall button again and hold it (for approx. 3
seconds) until all readings are deleted.
NOTE: Readings from individual measurements cannot be deleted.
(3) When data has been deleted the
displayed on the screen.
19
mark will be displayed (Fig. 11-a).
mark and

Setting (checking) the measurement notification time

Fig. 12-a
Fig. 12-b
Fig. 12-c
Fig. 12-d
Fig. 12-e
will be
To let you take measurements at the same time every
day, 3 times per day can be set as notification times.
1. Press the Set button on the top surface of the blood
pressure monitor (Fig. 12-a).
• Notification Time 1 will blink (Fig. 12-b).
* If date and time have not been set, the display will
change to the date/time setting display.
2. Press the Set button again.
• The and will blink (Fig. 12-c).
3. Press the Adjust button to display
• The and will blink (Fig. 12-d).
• Notification sound will sound.
• Notification sound will not sound.
• When is displayed and the Set button is
pressed, the time becomes
and will light.
4. (1) Press the Set button. The hour value will blink
(Fig. 12-e).
(2) Press the Adjust button repeatedly to set the
desired hour.
.
and the
20