Casio Exilim EX-ZR10 User Manual page 60

. To shoot a Prerecord Movie
1.
After using the above procedure to set up the camera for Prerecord
Movie, point the camera at the subject.
2.
When you are ready to record, press [0] (Movie).
This will save the approximately five seconds of action that was prerecorded in
the buffer before you pressed [0] (Movie) (two seconds if you are using high
speed movie) and start real-time recording.
3.
Press [0] (Movie) again to stop recording.
• To turn off Prerecord Movie, press [SET], use [8] and [2] to select the bottom
Control Panel option (BS) and then select R (Auto).
• When shooting with the high speed movie "30-240 fps" setting, you cannot
change the speed (fps) setting while the camera is pre-recording to the buffer
in step 1 of the above procedure. You can change the speed (fps) setting after
you press [0] (Movie) to start real-time recording.
NOTE
• While the camera is set up for shooting with Prerecord Movie, pressing the shutter
button will not shoot a snapshot unless movie recording is in progress. With high-
definition (FHD) and standard (STD) movie, you can shoot still images while
realtime movie recording is in progress.
• When shooting with Prerecord Movie in combination with high speed movie,
pressing the [4] or [6] key will not change the EV shift or white balance setting,
even if "EV Shift" or "White Balance" is assigned for the "L/R Key" function. To
change the EV shift or white balance setting in this case, use the control panel.
60
Recording Movies