Table of Contents
Advertisement
M o u n t i n g H a r d w a r e I n s t a l l a t i o n
Some mounting hardware is easily installed using only your fingers. Press
the bushing pin into the shock eyelet bushing until the pin protrudes from
both sides of the eyelet an equal amount. Next, press an end spacer, large
diameter side first, onto each end of the bushing pin. If this works, you have
completed mounting hardware and bushing service.
If you are unable to install your mounting hardware using your fingers, use
the RockShox rear shock bushing removal/installation tool.
1
Thread the small end of the push pin onto the threaded rod until the
push pin is flush or slightly protrudes from the hex-shaped end of the
push pin.
2
Insert the threaded rod through the shaft eyelet until the push pin rests
against the bushing pin.
3
Thread the large, open end of the catcher onto the rod until it rests on
the eyelet.
Mounting Hardware Installation
40
Advertisement
Table of Contents
