Installation & Connection; Mains Connection; Audio Connection - Alto X34SW User Manual

11. AC Inlet
This connector is used to connect the supplied main cord. Please don't plug power cable into unit and AC power if
voltage has not been properly set.
12. L/M/H Output Connectors
These balanced XLR connectors are used to output the Low/Mid/high frequencies signals.
13. Stereo Input Connectors
These balanced XLR connectors are used to input the program sources.
14. Subwoofer Output Connector
This balanced XLR connector is used to connect your subwoofer amplifier.
4. INSTALLATION & CONNECTION

4.1 Mains Connection

Please ensure that the
power cord into the wall outlet, use the same fuse as marked on the fuse holder at the AC
The mains connection of the
standard IEC receptacle. It meets all of the international safety certification requirements.

4.2 Audio Connection

The LTO X34SW Active Crossover
support a variety of applications without any signal loss.
a. Wiring Configuration
Either the 1/4" TRS (Tip-Ring-Sleeve) jack or the XLR servo connector can be wired in balanced and unbalanced
modes. Please wire your systems as the following examples:
For 1/4" Phone jack
TS Type Unbalanced
For XLR connector
XLR Type Unbalanced
LTO X34SW Active Crossover is set to the correct supply voltage before plug
LTO X34SW Active Crossover is made by using the enclosed mains cord and a
presents with balanced XLR connectors, and it can be interfaced by several ways to
+
Tip
Sleeve
Pin2 (+)
Pin3 (-)
(Linked to Pin1 manually,
Pin1 ( )
+
-
Tip
Ring
Sleeve
TRS Type Balanced
Pin3 (-)
)
6
power connection socket.
Tip
Ring
Sleeve
TRS Type Unbalanced
Pin2 (+)
Pin1 ( )
XLR Type alanced B
ging the
+