Advertisement
Ok, you have got to this point and you are now in the position to operate your X23
successfully. However, we advise you to read carefully the following section to be
the real master of your own mix. Not paying attention enough to the input signal
level, to the routing of the signal and the assignment of the signal will result in
unwanted distortion, a corrupted signal or no sound at all. So you should follow
this procedure for every single channel:
5.1 Mains Connection
Please ensure that the X23 is set to the correct supply voltage before plugging
the power cord into the wall outlet, use the same fuse as marked on the fuse
holder at the AC power connection. The mains connection of the X23 is made by
using the enclosed mains cord and a standard IEC receptacle. It meets all of the
international safety certification requirements.
5.2 Audio Connection
The X23 presents with balanced XLR & 1/4" TRS and combo connectors. It can
be interfaced in several ways to support a variety of applications without any
signal loss. The X23 can be used on a single instrument by connecting to the
mixing console's main inserts, or on an entire mix "in-line" between a mixing
console's outputs and a power amplifier. The defective wiring may degrade the
performance of X23, so please use good quality screened audio cables only.
Please follow the guide below to interface X23 without experiencing any noise
or signal loss.
Strain Clamp
Strain Clamp
6
5. INSTALLATION AND CONNECTION
Tip
Sleeve
Ring
Use for Headphone
1/4" Stereo (TRS) Jack Plug
Tip
Sleeve
Use for Mono Line In, Mono 1/4" Jack Plugs
1/4" Mono (TS) Jack Plug
Ring=Right Signal
Sleeve=Ground/Screen
Sleeve=Ground/Screen
Tip=Left Signal
Tip=Signal
Advertisement
