ECS H310CH5-TI2 User Manual page 12

Step 4. Connecting Cables and Power Connectors:
a. Connect the SATA hard drive to its
SATA cable
c. Connect the power cable to the DC-in
19V jack on the rear panel I/O
Step 5: Connecting ports on the case:
Once the steps above have been completed, please connect the peripherals such
as the keyboard, mouse, monitor, etc. Then, connect the power and turn on the
system. Please install all the required software.
Using BIOS
The BIOS (Basic Input and Output System) Setup Utility displays the system's
configuration status and provides you options to set system parameters. When
you power on the system, BIOS enters the Power-On Self Test (POST) routines,
please press <DEL> or F2 to enter
POST screen may show a "CMOS Settings Wrong" message. Please
choose "Load Default Settings"
system hardware such as different CPU, memories, etc. may also trigger this
message.)
The sequence of installation may differ depending on the type of case and
devices used.
10
b. Connect SATA power connector to the
SATA device
setup. When powering on for the first time, the
to reset the default CMOS values. (Changes to
enter BIOS and