Page 1
Instruction Manual SmartFlow Mounting Frame Replacement Set Installation manual 5288509 / Version 00.001 / June 2021 / EN Original instructions Dairy Farming...
Caution Install the system according to the local rules and regulations. Caution We advice to install and maintain the Nedap product with at least 2 persons. Working environment Caution The installation area must be free from any obstacles, including animals.
Page 4
1. Mount the bracket on a flat surface, for example a wall or a plate. Use appropriate mounting material. Make sure there is at least 10 cm free space above the bracket. a. Use the drilling template that is delivered with the SmartFlow to mark 3 drilling holes on the wall or panel.
Page 5
Use the two lower screws of the bracket to level the bracket in the sidewards direction (left or right). e. Tighten the 2 lower screws to lock the bracket. SmartFlow Mounting Frame Replacement Set / Installation manual Dairy Farming...
Page 6
2. Place the SmartFlow in the bracket as follows: a. Press the push button at the bottom of he bracket backwards to open the hinges. SmartFlow Mounting Frame Replacement Set / Installation manual Dairy Farming 5288509 / Version 00.001 / June 2021 / EN...
Page 7
Slide the lower part of the SmartFlow in the hinges and release the push button. c. The hinges are closed and the lower part of the SmartFlow is now fixed in the bracket. SmartFlow Mounting Frame Replacement Set / Installation manual Dairy Farming 5288509 / Version 00.001 / June 2021 / EN...
Page 8
Press the lever at the top of the bracket and slide the ridge of the SmartFlow under the lever. e. Release the lever to snap the upper part the SmartFlow. SmartFlow Mounting Frame Replacement Set / Installation manual Dairy Farming...
Page 9
The SmartFlow is now mounted firmly in the bracket. 3. Level the bracket in forward-backward direction: a. Loosen the cover brackets of the SmartFlow. SmartFlow Mounting Frame Replacement Set / Installation manual Dairy Farming 5288509 / Version 00.001 / June 2021 / EN...
Remove the cover and spreader plate. 4. Use the screw on top of SmartFlow to level the bracket in the forward-backward direction. 3 Handling instructions Storage • If the product is to be stored for some time, make sure that it is under a protective cover to prevent dirt and moisture from entering.
Page 11
• Do not expose the product to direct sunlight and / or adverse weather conditions such as storm, rain, hail or snow. • Storage temperature range: -20 to 70 °C (-4 to 158 °F). • Relative humidity < 93% Disposal The owner or last user of the product is responsible for the proper disposal of (parts of) the product according to local rules and regulations.